You also need to be careful when tightening the bolts on the cat back. Over-tightening can damage the system, so just make sure they're tight enough to hold everything in place. It's important to make sure that the cat back is properly aligned with the exhaust pipe. If it's not, you could end up with an inefficient or even dangerous exhaust system. Competitors often rely on generic silencers or gimmicks that claim to cut out drone without any real knowledge or development involved.
Unlike your stock system, CORSA exhaust systems don't utilize performance-robbing restrictions that reduce airflow, such as chambered designs, baffles or spring-loaded valves. With wider tubing and our mandrel-bent design, your new full exhaust system will allow for reduced backpressure and provide cleaner oxygenized air to your engine. You'll see benefits like increased horsepower, torque boost and better fuel economy.
Finally, the catalytic converter can become fouled over time, resulting in a loss of power. This can be remedied by having the converter cleaned or replaced as needed. When it comes to choosing the right cat back for your car, there are a few things you need to keep in mind. First, you need to make sure that the cat back you choose is compatible with your car's make and model. Are you an aggressive driver who likes to take corners at high speeds?
A cat back exhaust system is one of the most popular aftermarket upgrades for performance-minded drivers. When deciding which type of exhaust system to choose, it is important to consider your needs and budget. If you are looking for maximum power and efficiency, a cat back exhaust may be the best option. However, if you are more concerned with cost and weight, a standard system may be a better choice. A cat back exhaust is one of the most popular upgrades for car enthusiasts.
Federal Catalytic Converters are not legal for sale, installation or use in the state of California. It should be noted that a split system will often provide an aggressive noise increase, and some designs will split the two pipes to opposite sides of the vehicle. If you are looking to save a little money but still get most of the benefits of a cat back exhaust system, however, aluminized steel may be the way to go. Made from traditional steel that’s been coated on all sides with aluminum-silicon alloy, these systems are very strong thanks to the metallurgical bond which still provides a level of corrosion resistance. While the aluminum coating reflects heat well, the steel can corrode if the aluminum layer is chipped or scraped off. Most cat-back systems will come in either an aluminized or stainless steel version.
By running pipes from the catalytic converter to the muffler and from the muffler to the exhaust tip, cat back exhaust systems improve exhaust gas flow, providing small performance boosts. However, your performance gains may be limited if your catalytic converter restricts gas flow, as a catback exhaust system is installed ‘downstream’ of the converter. Header-back systems are increasingly rare, namely because of modern emissions systems. Since removing your vehicle’s factory emissions components is highly illegal, the previous two options are more common. However, header-back systems are still available for some older, pre-emissions applications. In these cases, header-back systems offer more performance and volume than cat-back or axle-back systems